What to do now
Turn off the water supply if possible and do not keep running cycles while F8E4 is active.
Error code
Maytag Maytag Dishwasher F8E4 Error F8E4: Meaning, Safe Checks and Official Source
The dishwasher detected water in the drip tray or a water-connection issue. Turn off the water supply if possible and do not keep running cycles while F8E4 is active. Do not keep running the appliance if the code returns or a safety sign appears.
Applies to: Maytag Dishwasher F8E4 support scope official Maytag Product Help article scope.Confidence HIGHLast verified 2026-07-30
Applies to
- Maytag products covered by the cited F8E4 - Error Code - Dishwasher article
- Displayed F8E4 code in that Maytag support scope
Region: United States. This page does not generalize the code to every Maytag washer.
What the code means
F8E4 is treated as a water-detected or leak-related condition. Maytag directs attention to water-supply connection points and proper hose routing.
Confirmed: Maytag’s official F8E4 dishwasher guidance focuses on checking water-supply connection points and sealing at the fill connection.
Can you keep using it?
no
When to stop
Stop immediately if water is present near electrical parts, the supply cannot be shut off, or leakage continues.
When to call a professional
Use Maytag service or a qualified installer if the connection cannot be made leak-free or F8E4 returns.
Safe checks
- Confirm the display reads F8E4.
- Check visible water-supply connection points for leaks if access is safe.
- Make sure the rubber washer is seated at the fitting.
- Do not run the dishwasher if water is visible under or behind it.
Confirmed by the manufacturer
- Water connection points may leak if fittings are not seated correctly.
- The rubber washer must be properly seated in the fitting.
- The fill hose should be routed out the rear left side of the unit.
Commonly associated with this fault
- Recent installation, a loose supply elbow, missing rubber washer seating, or visible water near the dishwasher can fit Maytag’s official F8E4 guidance.
Not confirmed for this exact model
- A failed inlet valve, float switch, control, harness, or tub seal is not confirmed by F8E4 alone.
Reset instructions
No reset procedure is published here because the current source does not document one for this scope.
Do not keep clearing or restarting if water remains visible or the source of leakage is unclear.
Information to collect before calling service
Record model label, exact F8E4 display, installation date, supply-connection condition, visible water location, and any reset attempts.